-
connect a goal zero to Zamp solar pannel;
I have a lightly used Zamp 140 watt solar briefcase with charge controller. I recently purchased a goal zero 1000 and would like to use the panels to charge but not sure if there is a workaround or way to safely bypass as the goal zero has charge controller as well? There is no quick disconnect for charge controller on…
-
Yeti 1000 Lithium fans always on!
I have a yeti 1000 Lithium that has no display, no response from controls but fans are on. any idea what is wrong with it?
-
Yeti 400
I have a problem with where the power plugs in? Sometimes if I twist and pull the blue light comes on and it starts charging. I think the the socket is worn sometimes it sparks ⚡️ can this be replaced?
-
Solar Charge with HPP and 2x 8mm question
Over the past year I have been charging the Yeti 3000x with two 320w panels on the roof, using a combiner cable and life has been perfect, maxed out at 550w of input on a great day of sun. I wanted to max out the Yeti and Installed two 225w panels each running the Yeti with an 8mm 30 ft extension. I figured after power…
-
Portable Power Banks
You guys are a lot richer than I am, otherwise I'd just pick one. Am I looking into something too much and too expensive for me ? Do.you have to buy solar panels or are they included? I just need a step up from a USB power bank and solar would be nice. Email me this probably won't be monitored. Owner@braceletme.services
-
1st Gen Sherpa 100AC Problem
I have an original 1gen Sherpa 100AC purchased in 2018. I am having problems with the AC output. With a fully charged 100AC when I press the AC outlet button, the blue LED does not activate. “AC” shows on the OLED panel briefly but disappears within a couple of seconds. Plugging an item into the AC outlet, it does not…
-
Controller for Nomad 200
I recently purchased a Nomad 200 to pair with a Solar on the Side plug for my camp trailer. I'm now realizing I need a controller as part of the hook-up. Which controller would you recommend?
-
New 1000X, wondering what a blinking blue light means
I just purchased this 1000X last night @ Costco in preparation for a camping trip that starts in 48 hours. I started it charging around 1AM. In the morning I saw that it was almost complete but the blue input light was blinking during the last hour or so of charging. Is that normal? The manual only describes that light as…
-
Input solar power into Yeti 6000x via car link?
Hi, I have a yeti 6000x with the Yeti car link. Do I need a separate mppt controller to input power from 2 x 100w Boulder solar panels into the 8mm input on the Yeti Car Link? Or is energy input into that port managed by the internal mppt controller in the Yeti 6000x? I understand that by inputting solar energy into the…
-
How to determine run time of a CPAP device on YETI1000
I have a Phillips Dreamstation II with a draw of 6.67 amps at 12 volts. Instead of using the supplied 110 volt transformer, I have a 12 volt cable for it. How do I compute how many days this power station will run the CPAP without recharging? I am planning on camping for 4 days and will not be using the power station for…
-
Light red on 12V output port?
The LeD on my 3000X 12V output port turned red. After pulling all input and output cables I tried: Pushing the 12V button to reset per manual: went white and immediatel red again Reset button inside the cover of the Yeti below the WIFI button: No change Pressing the Unit and Light buttons simultaneously: No change…
-
can yeti1400 power a Espar/Webasto van heater
anyone running an Espar/Webasto gasoline heater with power from Yeti1400? thanks!
-
Connecting Boulder 200 Panels to an Inverter in an FJ80
I'm a huge fan and long time supporter of multiple GoalZero devices that I routinely use camping and overlanding. I have an FJ80 Land Cruiser that has an onboard inverter with a secondary battery to help power devices while offgrid. While I've used both by Boulder 200 and Yeti 500X to supplement power individually, I've…
-
Another Vehicle Integration Q
I have a 3000x arriving this weekend and I plan to use it in a Sprinter van. I see there are two high power output ports. One under the lid and one on the face of the unit. They are both rated at 30 amps. Can these be safely connected in parallel with a terminal block to send 60 amps to a fuse block? I know it's possible…
-
Solar quit charging
I have a new to me open box Yeti 1500X and am checking it out with my new portable Dometic CFX3 55 Liter fridge. The 110 VAC works consistently for charging but the new Renogy Flexible 100W panel did not. When I first plugged the panel in to the input Anderson PowerPole, it worked great for the first few minutes. Then it…
-
Sistema eléctrico
Quiero saber primero como cargo el banco de energía en cada no hay explicación técnica ni video y en caso de ser 220 volt 60Hz hay en inventario bancos con estas características en existencia para usar en mi país que usa sistema europeo. Espero su pronta aclaratoria gracias.
-
Best Practice for everyday use
I have 1500X. I use it every night to power my CPAP machine in case power goes out. What is charging best practice for this scenario? It is plugged into smart device in my smart home. I can literally charge it or not any time, or condition. ie. Remainig capacity It uses about 20% of the battery every night. It is set on…
-
Yeti 500 - Hot water kettle
Any issues/limits on plugging a hot water kettle to get boiling water?
-
I let my Yeti 500 Lithium go completely dead (zero charge).
When I plugged it in, the display came to life but the input power is showing 0 watts. How can I bring it back to life?
-
Solar panel for Sherpa 100AC (new)
Hey guys I’m looking into buying a Sherpa 100AC new version and I have a nomad 7 solar panel. will I be able to recharge the power bank? does this make any sense? Or the panel is just to small. I will be going to a place up in the north with sun day and night … take into consideration please hehe…
-
Yeti 500X will not charge
I let my new 500X un attended for 6 months and recently tried to get it up and running for the season. The display came to life when I plugged it in but is showing 0% (8 volts) and even plugged in, the input power is 0 watts. Is there something I can do to get it back up and running? Mike B
-
1500X MPPT board replacement
Does anyone know where I can get a MPPT board for a 1500X? I got my system used at an REI garage sale, and since you can't really test solar in a store, I didn't know that didn't work till I got it home. Since it was used, it isn't covered by warranty. One of the AC jacks was bad also. I have already tried doing multiple…
-
Overloaded
I have the 3000x. I have been running a sump pump that feeds my greenhouse from a nearby creek. It has been working fine for two weeks now. The sun has been keeping battery well charged. I just went to check on the greenhouse and the a/c button is red and lcd screen reads Overloaded. Is it due to heat in greenhouse? Thank…
-
deleted
-
Is the blue input light supposed to blink during charging?
-
connecting two yeti 400's
If I use the chaining port between two Yeti 400's and the first yeti is connected to a power source, by chaining the two, will the second (without a power connector) yeti get charged OR do I also need it to be powered to source as well?
-
Equalization with Victron 100|30 MPPT?
Hello, Should the Yeti Tanks be equalized? If so I assume it's the voltage and duration specified by the rotary setting on the Victron? Thanks very much! Steve
-
double charging
Hi I have a goal zero 1250 and am connecting 200w of fixed solar using the anderson connection. My question is while its being charged by that am I able to to charge it additionally with a foldable solar panel using the 8mm connect or even the 12v car charger into the 8mm connect at the same time as my fixed solar
-
Yeti 1400 not working
My Yeti 1400 is not working for my 12v fridge below 60% capacity of the battery. Any idea what to do. Dine the three bottom reset already? thx for answer
-
100 boulder briefcase with boulder 100
Hi, can I connect my Boulder 100 briefcase to a Boulder 100? (using the Anderson combiner). I have a Yeti 1000. Thanks