How Do I Reset My Yeti Power Station?
Yeti 200X Reset:
1. Press and Hold the 12V and AC button for 15 seconds.
2. At 15 seconds, let go and everything should shut off on the unit.
3. Try turning on and using the unit.
Yeti 500X Reset:
1. Press and hold the units and info button.
2. The display will disappear (except for the battery icon) and then come back.
3. Once the display is back, you can let go and the reset is complete.
Yeti 1000X Reset:
1. Press and Hold the units and Info button simultaneously for about 7-10 seconds.
2. You will see the screen go blank and come back. This means the unit has been reset.
Yeti 1500X, 3000X and 6000X Reset:
1. Press and hold the reset button below the lid (that is the button in the green circle) for 5 seconds
2. The screen will go blank and come back.
3. Once the screen has returned, reset has been completed.
Factory Reset:
1. Press and hold the units and info button until it starts to beep.
2. Once beeping, release the button and allow to beep until it stops. (Typically 1 minute)
3. Once beeping has stopped, that means the unit is reset.
If on Firmware 1.7.6 or higher:
1. Press and hold the info button and reset button under the lid (the one in the green circle) for 5 seconds.
2. The unit will shut down and be unresponsive for 30 seconds to a minute.
3. Once unit comes back, try charging it.
Yeti 400 and 1000 Li Reset:
1. Press and Hold the units and Info button simultaneously for about 15-30 seconds.
2. You will see the screen go blank and come back. This means the unit has been reset.
Yeti 1400 and 3000 V2 Reset:
1. Press and hold the reset button below the lid (that is the button in the green circle) for 5 seconds
2. The screen will go blank and come back.
3. Once the screen has returned, reset has been completed.
Factory Reset:
1. Press and hold the units and info button until it starts to beep.
2. Once beeping, release the button and allow to beep until it stops. (Typically 1 minute)
3. Once beeping has stopped, that means the unit is reset.