Yeti 1000x with 2 expansion tanks
I ordered 20-Amp Charge Controller to attach to my solar to charge the expansion tanks. I assume that this is the correct setup? I can't find an 8mm to connect to the controller. Any ideas or am I trying to set something up incorrectly?
Comments
-
Hi @Yexotay
What solar panels do you have? The 20 amp charge controller is meant to be used with larger panels that have HPP cables. You might just need an adapter.
https://www.goalzero.com/products/8mm-to-hpp-solar-adapter?_pos=6&_sid=048168307&_ss=r
-
I have HPP connector from the panels, the controller needs to plug into the expansion module 8mm female.
-
I don't think there is an sae connector to 8mm to plug into the expansion tank charger port?
-
Hi @Yexotay,
The 20A charge controller can't connect to the Yeti link 8mm port. The Link is also a charge controller so this would not work. Instead, you will need to connect it directly to the internal battery of the tank using the SAE to ring terminal or SAE to alligator clamps. This will allow a charge through the 20A charge controller.
