Connecting Yeti 1500x to 12v distribution block

mikes8500

Hi, I'm trying to connect the high power 12v output on my Yeti to a distribution/fuse block for a couple of appliances in my van. How would I do that? The only way I see is to take one of the high power cables, cut an end off and attach ring connectors to the wire then to the block. Is there a better way? Thanks.

jg164

Hi @mikes8500,

We sell a 6mm to ring terminal adapter but I would not use it for more than 60W.

6mm Male to Ring Terminal Adapter – Goal Zero

If you are comfortable using 3rd party products this might work if your dist block is close to the yeti

https://www.amazon.com/iGreely-Terminals-Connectors-Automotive-Compatible/dp/B07ST82H9H/ref=sr_1_3?crid=2SKMZNA2WJWMH&keywords=power+pole+to+ring+terminal+20+feet&qid=1656626109&sprefix=power+pole+to+ring+terminal+20+feet%2Caps%2C117&sr=8-3

If its further out you can make your own. The crimpers and connectors are not too expensive.

Something like this

https://www.amazon.com/Ratchet-Crimping-Connectors-Connect-Battery/dp/B07QPZWFHJ/

Make sure to use 10 AWG wire and keep the length as short as possible