-
Crush Light Instructions
Just got our crush lights. Charged fine but can't figure out what sequence of button pushes to have it be just one solid color. Help please! TYIA
-
Starlink Mini
looking at getting a starlink mini and curious if anyone is powering with a sherpa100ac with success? i have seen a lot of ppl using a yeti300. thx
-
Travel Mode question
How do I put a Venture 35 in "travel mode"? I had a problem with the first unit but Goal Zero happily sent a replacement. I'd like to make sure I'm storing it properly so, it's ready when I need it. Thanks!
-
Springs for Yeti 12V Car Charging Cable?
The connector on the vehicle end of the Yeti 12V Car Charging Cable came loose and all of the components popped out. I found one spring, a fuse, a solid metal piece, but the second spring is missing. Are the springs available from Goal Zero? If not, what are the dimensions/specs? Thanks
-
Fully charged Venture 35 dies
My 3 month old Venture 35 seems to lose its charge after a few minutes of being plugged in to a device to charge it. And, that’s after it’s been fully charged. Will a reset fix this? Or, time for a warranty claim?
-
Replacement manual
i cannot find the manual for our Yeti 1400. How con I obtain a replacement?
-
Amount of Panel Watts per kW-hr battery system
I have been testing my new power stations I received about the middle of September. The intent is to verify that they will perform as I need when the time comes. I have one Yeti 200X and one Yeti 1500X. The Yeti 200X was ordered with a 20W Nomad Panel, and the 1500X was ordered with a 100W Boulder Briefcase Panel. I…
-
Yeti 1250 and RV House batteries!!!
hi group!!! I am wondering if any of y’all have married a yeti 1250 to your rv house batteries? Y’see the 1250 if I’m not mistaken uses AGM batteries and accessorizes a big Anderson to battery expander in the rear. So I’m thinking I connect the expanded batteries as the existing house batteries or pull the batteries in the…
-
DC to DC charger rather than MPPT in Expansion Port
On a Yeti 1400 Lithium I'd like to connect a DC to DC charger using the same configuration as the Victron External MPPT controller. That is to go from: Battery (alternator) - to - Victron DC to DC charger -to- EC8 connector under the lid of the yeti. After a quick call with tech support, it sounds like the port will take…
-
first GZ camping, what to improve?
Just got back from 4 day camping by thigh deep stream, wife's extended family camps here every year, no where else for there are lots of trees…great for shade, drag for solar! Using GZ for last 15 years some batteries have died due to age. Had several discussions for not being with family but guarding GZ gear, no…
-
500x inverter problem
I have a 500x and the A/C button turns red after about 2 seconds with 3 beeps. The screen shows overload with nothing plugged in. I’ve tried resetting it several times. The button stays lit red and won’t turn off and there is no A/C current. Any suggestions?
-
Two Yeti6000X
We just got a second Yeti6000X on sale. The app says we can add a second Yeti to the first. What do I need to know? Manual doesn't cover it.
-
Where can I find instructions for the Flying Leads to Power+ Cable?
Where can I find instructions and a wiring diagram for the "Flying Leads to Power+ Cable"? I presume that this cable is for charging the Yeti Pro 4000. Is this correct? Does the cable expect 120VAC, or 240VAC? Is the charging speed for this input fixed, or can it be adjusted from the App?
-
Chaining 2 lead acid 12 volt 35 Ahr batteries to the Yeti 400
Can I chain two 12 volt 35 Ahr batteries to the Yeti 400 lead acid power station using direct connections to both left and right Anderson power pole connections? If so, are there any special considerations or connection concerns or can it be direct connection? Thanks, Mark Mark.wheeler3575@gmail.com
-
Advertising!
You folks need to step up your advertising on the Weather Channel! All I’m continually seeing is the monstrous fuel-eating Generac and occasional wave at the Patriot brand. Our Yeti6000X is ready for Debby!
-
Charging a Yeti 1500X on cloudy days.
I'm looking for alternatives to charge my Yeti 1500X on cloudy days. For example, could a XHNCXHX Hand Crank Generator be used. Thanks.
-
Small wind turbine
Hi - I'd like to get a small wind turbine to work with my Yeti (1500X). I saw an earlier thread that didn't really have an answer, beyond 24V as the input goal. Any other advice? Team YETI/Goal Zero, this seems like one that the corporate office should be interested in, no? I would happily buy something that was guaranteed…
-
My history is not working in the app
I have yeti1500x and yeti link And in the app the history is blank . It worked in the past Filmwhare version is 18.8 I did reset the unit but did not work I reinstalled the app did not work What can i do ????
-
Yeti 200x stopped charging from rear input
My yeti 200x stopped charging from the rear input. I can charge it from usb c input on the front. I have tried resetting the device multiple times. I have used different goal zero chargers that I have used successfully on my other yetis but don’t work on this 200x. Seems like the input is dead. Is there a fix for this? Can…
-
Yeti 300 Fan Behavior and Overtemp Warning
I got a new Yeti 300 recently and I've been putting it thru some typical usage scenarios. My experience so far has been that the way the fans are controlled makes it quite easy for it to end up with the overtemp warning on in normal use in a ~70f air conditioned room. As far as I can tell, there are 3 fans in the Yeti 300.…
-
Update impossible yeti 1500x
Hi, is impossible to update firmwqre, i have 1.3.0 and try to update 1.8.8 I can t cloud connect… with direct connect i clic on update... after connect to wifi... station make 15 bip bip... i wait 10 minut... reconnect and formware no updated... Can you help me? thx
-
Yeti 500 Dead, Not Charging
Yes I have contacted the customer support line but have not heard from them since I gave up on a phone call Monday and still not received an email reply. I have a Yeti 500 that has been plugged into AC power since I bought it in June (as recommended by the website), it has not been used other than some testing with the…
-
Yeti 1000 question
Trying to figure out what is going on with my Yeti 1000. Had to replace the charger and now I get this. It was out of action for months, so maybe the battery is no longer in good shape… but this seems to be something else.
-
Goal Zero Adapter Cables in Series or Parallel?
Do these two types of Goal Zero combining cables put the panels into series or parallel? The 4x8mm to HPP and the 4xHPP to HPP. Thanks https://www.goalzero.com/collections/solar-accessories/products/4x-high-power-port-combiner-to-high-power-port-connector
-
Wall Charger very hot
I have a new Yeti 1500 that I use as a battery backup for two cpap machines. As per the instructions I setup the battery to always be plugged into the wall. I placed the charging adapter under the top door. The AC adapter gets very hot. It got so hot that it discolored the plastic underneath where the adapter was sitting.…
-
No Solar Charging to Yeti 4000 Pro
I haya Yeti 4000 Pro with an HPP+ solar array combiner with 12 goal zero 100 watt panels. Worked perfectly the first weekend. It was around 100 degrees all week. Second weekend, not working at all. No Solar input into the yeti. Tried soft reset. Tried unplugging and replugging the hpp+ extension cord into the yeti. Tried…
-
1500X surge
What are the odds of the 1500X handling the surge of a typical 1000W vacuum cleaner? Has anyone tried it?
-
Yeti 6000X the 230VAC is faulty
Does anyone have experience of which electrical components usually fail in a 230 inverter? I need the 6000X very urgently and there are no spare parts available in Europe? Can anyone give me a tip? I am able to replace the components myself.
-
Yeti 200x charging issue
My yeti 200x that I purchased last year from Bass pro shop is stuck at 0% charge. I was charging my phone on it camping out the other day, I disconnected my phone and it read 80%. I go eat breakfast and come back and it said 0%. I plugged in the charger and nothing happened. I got home and left it plugged in for 3 days and…
-
Network ID and password for Yeti 4000
How can I change the SSID and/or default password for the Yeti 4000? It seems that anyone who is in range of my unit could access it with the app installed on their own device. Then, without even logging into an account, they could change my charge profile, enable/disable AC/DC/USB, and reset the cycle and statistical…