-
HowTo get 1500X in towed camper charged from car while driving?
We want to have our 1500X in our camper while towing and have it charged from our car. How can this be done? can it be charged off the power from the existing 7 pin trailer harness that connects to the trailer's lights and ebrakes? How do integrate the YETILINK VEHICLE INTEGRATION KIT into that config ...... or do we just…
-
Using Haven 10 with two Yeti 6000X
Can I use a 30A generator adapter with two 15A standard input plugs to connect to the New Haven 10? Something like the below: Thanks!
-
Outdoor unattended application requires 5V regulated supply
Hi - I've an outdoor, remote application that requires a 5V regulated battery pack that will supply a powered USB extender and a light meter + data logger. The environment (where the battery pack will rest) may range from -5 F to 105 F. The low temps will occur only infrequently during some winter nights; the higher temps…
-
Yeti 1500X - Display Won't Stay Off
I'm having a bit of an annoying issue with my 1500X - when I turn the display off, it never stays turned off. I think it's an issue with the solar power being intermittent - essentially whenever it sees solar input it turns the display on. Since my camper (where the Yeti lives) is often in partial shade, this means it's…
-
Water damage
Rain water got into my Goal Zero Yeti 150. It's not working Is this something that can be solved w a new battery or do I need to buy a new generator?
-
Charging with a wind mill??
I wanted to buy one of the systems , but also wanted to buy a windmill from amazon and see if I can also charge at night when the wind blows and the sun is not out. Can I charge the battery with such a wind mill? what voltage should I get 12VAC , 24vdc....etc Thanks J
-
Boulder 100 with loose contact?
Hi Until recently, my Boulder 100 worked nicely together with a Yeti 200x. For two or three weeks, the Yeti is not showing the blue battery indicator anymore when plugging in the Boulder's plug. When I turn the plug around or "massage" it a little bit, the Yeti starts charging. To check whether it is the Yeti's or the…
-
Yeti 1400 not charging
Just purchased a 98350 YETI X 230W 120V Power Supply wall charger. Whenever I plug it in the yeti tries to charge, fans turn on them in about 2 seconds it stops, 10 seconds later it tries again then stops this process repeats itself indefinitely.
-
1 of my plug outlets isn't working, how can I fix that?
How can I fix my plug outlet?
-
500X won’t fully charge
After fully charged the output at 20% is only 178WH. Can this be fixed.
-
Yeti 200x wont charge past 7%
After several hours, max 7 % charged. When plugging it it sounds like small fan goes on but that stops quickly. I charged it for 6 hours and no higher than 7. Plugged laptop into it and lost the juice in a few minutes. Tried to reset holding 12v and AC and nothing. 18 months old.
-
Tengo un generador yeti 400 y el la pantalla sale que el inversor esta fallando
donde tiene la marca de color se escucha un ruido como en corto en la tomacarriente alcanza a enviar 60v y vuelve y sale el simbolo del inversor en la pantalla y se va el voltaje bicado en colombia
-
Lighthouse Micro Cycles all modes then shuts off
My Lighthouse Micro when turning on cycles through all modes, flashlight then dims down, full lantern then dims down, half light lantern then dims down then off. 😪 Light is totally fine, recharge, etc, but obviously a control chip issue somewhere... Not very "zero" if I unfortunately have to just send it to the box of…
-
Skylight Highlights
With the launch of our new Skylight, we wanted to highlight some of the key features that the light comes with. Protective (not waterproof) hard carrying case with hand and shoulder strap Quick release button for set up and take down Individually adjustable legs for leveling 6 Multi-Directional LED petals 12ft+ steel…
-
Sherpa 100 PD (4th Gen)
Hi I have a Sherpa 100 PD (4th Gen). I was charging it today. Everything was normal. When took it to check the percentage ı saw that there is no display. Tried to charge my phone but nothing. Anyone had this problem? Or any answers ?
-
Can I plug both a Nomad 100 and Nomad 200 into my Yeti 1000X at the same time?
I have a nomad 100 with an 8MM output and a Nomad 200 with a HPP output Can I plug them both into the Yeti 100X at the same time ?
-
Home A/C
Hello all. Is there a way to use the home backup to support a 4 ton heat pump A/C? It’s a 220 volt with a 15amp minimum.
-
Link Battery Module not working
So I have an off grid cabin used from April to October only , I have a Yet 1400 with the Link module attached to 4 6V 220ah lead acid batteries .I have 600 watts of roof panels with excellent south facing exposure . My main power use is a 12 V hi efficiency fridge , some tactical nite lights , and 2 fans for hot nites .…
-
uPd under output?
When using my 3000x I sometimes see a flashing "uPd" code on the screen under the output section. There isn't any description of what this means in the manual. Is it simply "updating" for the output measurement or something else?
-
Firmware update hangs
I have the Goal Zero 3000. I tried to do the firmware update from 1.8 to 1.86, and at first I couldn’t get the connection to remain stable. After about two hours of resetting and the like I got the stable link, but when I click update the firmware, nothing happens. I click it again, and it says that it is in progress, but…
-
Yeti Link No Longer Charging my 1000X
I have had my Yeti 1000X, with link for over a year now, and the link is no longer charging my yeti. It will charge and hold the expansion batteries I have hooked up, but not the Yeti. I have pulled the link and disconnected it, then re-connected tit with the same results. The system worked great for 18 months without…
-
Costs of Battery Replacment
Hi, l would like to know the costs of the battery replacment service provided by goal zero. Especially interested in the 3000x model, but also in general. Thanks
-
How does the Link Module Firmware determine charging amperage?
I use a 1500x with a Link Module in my campervan. I charge it from the van's 150 amp ("non-smart") alternator. I use the 12ft EC8 extension cable with the male EC8 to ring terminal cable so the total run from the vehicle battery to the Yeti is about 13 1/2 ft. The charging profile always starts out at 60 amps very briefly…
-
Adding additional Expansion Tanks
Is there any issue with adding brand new expansion tanks to an existing setup with a couple 1 year old expansion tanks? Or, is it best that all tanks be the same age? Thanks. Don
-
Putting my yeti 6000x in a weather proof enclosure, bad idea?
I have a yeti 6000x that I need to have outside near the solar panels. It will be on a covered porch so it would not get too wet leaving it out. But I want to put it in a weatherproof container. I would prefer a container not much bigger than the yeti. Do I need to worry about air circulation? If so, would drilling a few…
-
Running a sump pump from a battery system
I have an odd situation. About once every 3 to 5 years I have a basement flood due to an extremely high tide. The water comes in at a high rate (>150 gpm) for a short time (not longer than an hour). Sump pumps that can handle this situation are available at a reasonable price. Since it is possible that this situation could…
-
Battery Trade-in program
LOVE my YETI 1000. But after 3 years as the only electric source i have in my tiny trailer home, it doesnt have the capacity it once held. Seems a trade-in program would be the best ECO practices to follow. Does Goal Zero have a Responsibility Plan to deal with the discharged battery from their products ending up in…
-
Shipping to Asia ?
I am from New York City, and I was wondering if I can purchase a Yeti 6000x with the appropriate solar panels and have it shipped to Manila, Philippines from your website. This is an international shipping question. Thanks.
-
Chaining a GZ Extreme 350 to SLA batteries
I have an Extreme 350 that I have refurbished with a new 12v 33ah battery, and I want to chain it to 2 other 12 33ah SLA batteries in parallel, and be able to use the Extreme UI inverter attached to my 350. How is this accomplished, since in creating parallel batteries, the power draws from the positive terminal of the…
-
Useable capacity of GZ 1200 Wh tanks
Hi, I would like to know what is the real world useable capacity of the GZ tanks. It is stated that their capacity is 1200 Wh, I believe. I now have HIK installed and currently just have a 1500x but plan on getting a 3000x plus 2-4 tanks or just a single 6000x. So, would the 3000x with 2 tanks provide a full 5400Wh (3000 +…